To clean polyester spandex brushed fabric, follow these general steps:
Check the care label: Always begin by checking the care label attached to the fabric. It should provide specific instructions on how to clean and care for the fabric. Follow any guidelines or recommendations mentioned on the label.
Pre-treat stains: If you notice any stains on the fabric, it's best to pre-treat them before washing. Use a stain remover or a mild detergent directly on the stained area. Gently rub the stain remover into the fabric with your fingers or a soft brush. Allow it to sit for a few minutes before proceeding to the next step.
Machine wash or hand wash: Polyester spandex brushed fabric is typically safe to machine wash or hand wash. If machine washing, use a gentle or delicate cycle with cold water. If hand washing, fill a basin or sink with cold water and a small amount of mild detergent.
Wash with care: Place the fabric in the washing machine or gently agitate it in the soapy water if hand washing. Avoid using harsh detergents or bleach, as they can damage the fabric. Instead, opt for mild detergents specifically designed for delicate fabrics.
Rinse thoroughly: After the washing cycle or hand washing, ensure you rinse the fabric thoroughly to remove any remaining detergent. Residual detergent can leave a film on the fabric, affecting its texture and appearance. Rinse until the water runs clear.
Avoid wringing or twisting: When removing the fabric from the washing machine or while hand washing, avoid wringing or twisting it excessively. Instead, gently squeeze out the excess water without putting too much strain on the fabric.
Drying: Polyester spandex brushed fabric is best air-dried to maintain its shape and texture. Lay the fabric flat on a clean, dry towel or hang it on a clothesline in a shaded area. Avoid direct sunlight, as it can fade the fabric or cause it to lose elasticity.
Ironing: In most cases, polyester spandex brushed fabric does not require ironing. However, if necessary, use a low heat setting on an iron or a steamer and iron the fabric on the reverse side. Avoid excessive heat, as it can damage the fabric.